Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Windows & Doors: The Miami Owner’s Guide
Tamko window and door replacement in Miami typically runs $5,310-$17,700 for standard units and $9,440-$29,500 for impact-rated systems, with most stock sizes available for install within 48 hours. We carry Tamko-compatible frames, sashes, hardware, and weatherseal inventory for the coastal Florida climate. Most Tamko owners discover a problem when they feel salt-air draft around a closed sash, spot frame corrosion at the weep holes, or notice the locking mechanism has gone slack after a tropical storm season.
Which Tamko Models This Applies To
Tamko’s window and door lineup spans several series, and the part you need depends on when your unit was manufactured. The Heritage Series vinyl windows (post-2012) use a distinct sash balance shoe that is not backward-compatible with the pre-2012 design, a gotcha we have seen cost Miami homeowners a second service call when the wrong part was ordered. The Builder’s Grade aluminum line, common in Doral and Kendall tract homes from 2015-2019, uses a proprietary corner key geometry that aftermarket suppliers rarely replicate correctly. We check the etched NFRC label on the glass spacer, the AAMA certification sticker on the frame jamb, and the hardware stamp code before ordering. OEM Tamko parts carry the full factory warranty but run 20-40% higher than equivalent-grade aftermarket components from AmesburyTruth or Truth Hardware; for hardware and weatherseal, we typically recommend aftermarket. For frame or sash replacement, OEM is usually the safer match.
Signs Your Tamko Windows & Doors Is Failing

- Draft around the sash perimeter even when locked. The compression weatherseal has hardened or shrunk, common in Miami after three to four years of UV and salt-air exposure. The seal should rebound when pinched; if it cracks or stays flat, replacement is due.
- Condensation between double-pane glass. The insulated glass unit (IGU) seal has failed, allowing moist Gulf air inside. This is not cleanable; the IGU must be fabricated to the exact Lite size and replaced as a sealed assembly.
- Locking mechanism spins or does not engage. The multipoint lock gearbox has stripped, often from forcing the handle when the sash is warped. On Tamko units, the gearbox is replaceable separately from the full lock rail, which saves roughly $80-$140 in parts.
- Sash drops or will not stay open. The constant-force balance spring has fatigued. In Tamko’s tilt-wash double-hungs, this is a block-and-tackle system rated for 10,000 cycles; coastal corrosion can cut that lifespan by half.
- Frame pitting or white oxidation at the sill. Anodized aluminum frames in Miami-Dade degrade faster within one mile of the coast. The weep holes clog with salt residue, trapping water against the metal.
Before
AfterReplacement Cost & What’s Included
Window replacement in Miami runs $5,310-$17,700 for standard vinyl or aluminum units, and $9,440-$29,500 for impact-rated systems meeting Miami-Dade HVHZ code. The spread depends on three factors: unit size, impact rating requirement, and whether the existing frame is preserved or fully replaced. A typical Tamko double-hung replacement using the existing frame (sash-pack or insert method) falls in the lower half of that range; full-frame replacement with new exterior trim and interior casing pushes toward the upper end. Our quotes itemize parts, labor, permit, and disposal separately. Under Clause 1 of the Haven Standard, you receive that written price before anyone picks up a tool. Every Tamko-compatible installation carries our 365-Day Done Right Promise, and the documented photo record is included standard.
DIY or Call Us?

An owner can safely inspect the weatherseal condition, operate the lock to feel for slop, and check the NFRC label location for our reference. What goes wrong fast: removing a sash without supporting the balance system can release spring tension unexpectedly, and impact-rated units weigh 40-60% more than standard sashes, a strain risk most DIYers underestimate. Improperly installed windows fail Miami-Dade wind-load inspection, which voids your windstorm insurance discount. We stock common Tamko balances, locks, and seal kits on our trucks for Miami service calls. Call (786) 321-4970 to schedule your free estimate.
FAQs
Expect 12-18 years for standard vinyl units and 10-15 years for aluminum in coastal zip codes, with impact-rated systems often outlasting both due to heavier frame construction. Salt-air exposure within a mile of Biscayne Bay accelerates hardware corrosion. Call (786) 321-4970 for an exact quote on replacement, estimates are free.
Hardware (locks, balances, operators) is usually repairable; failed IGUs and corroded frames are not. We diagnose on-site and will tell you straight if a $45 balance repair saves a full replacement. Call (786) 321-4970 to schedule your free estimate.
A single sash or IGU swap takes 90-120 minutes; full-frame replacement runs 4-6 hours per opening, plus trim cure time. Most Miami-Dade permits for like-for-like replacement clear electronically within two business days. Call (786) 321-4970 for an exact quote, estimates are free.
We stock balances, lock gearboxes, weatherseal, and operator arms for Heritage and Builder’s Grade series; IGUs and full sashes are fabricated to order from Miami-area suppliers with 3-5 day turnaround. Call (786) 321-4970 to confirm availability for your model.
Rowan Construction Group Miami is an independent service provider and is not affiliated with, endorsed by, or sponsored by Tamko Building Products, LLC.
We also stock and install parts for KraftMaid cabinetry, Cambria countertops, and Silestone surfaces.
Written by Grant Rowan, Owner, Rowan Construction Group Miami at Rowan Construction Group Miami, serving Miami and nearby areas.







Before
After
Before
After