Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
PGT Fence Installation: The Miami Owner’s Guide
PGT vinyl and aluminum fence systems installed in Miami typically run $4,130-$10,620 for a standard residential lot, with most Coconut Grove and Coral Gables projects falling in the $6,500-$8,200 range. We stock PGT-compatible posts, rails, and gate hardware for same-day replacement on failed sections. Most Miami owners discover the problem when a tropical storm or king tide exposes the real condition: a post that wobbles at the base, a rail that pulls from its bracket, or a gate that sags enough to drag the pavers.
Which PGT Models This Applies To
PGT’s fence line breaks into two series that handle South Florida’s salt air differently. The PGT Vinyl Privacy series uses 5-inch square posts with wall thickness of .150 inches, while the PGT Aluminum Estate series runs 2-inch square posts with powder-coated 6063-T6 alloy. The label is stamped on the inside face of the post cap, or on a small aluminum tag under the bottom rail bracket. If the tag’s gone, measure the post wall: vinyl under .130 inches is typically a competitor’s import, not PGT.
We’ve found the OEM PGT rail bracket holds up better than aftermarket equivalents in Miami’s UV exposure. The aftermarket versions save $8-$12 per bracket but the nylon insert degrades in 18-24 months here. For gate hinges, we use PGT’s stainless steel kit or a Marine-grade equivalent from a vetted supplier, never the zinc-plated hardware that corrodes at the hinge barrel within two wet seasons.
Signs Your PGT Fence Installation Is Failing

- Post wobble at the concrete footing. In Miami’s sandy loam, especially in Pinecrest and Palmetto Bay, the post base rots or the concrete footing cracks from root intrusion. The post leans toward the failed side and the gate won’t latch square anymore.
- Rail pull-out from the bracket. The vinyl rail tab cracks where it meets the bracket, usually from thermal expansion stress after 6-8 years of 90-degree daily swings. You’ll see a gap between rail and post, or the rail drops slightly on one end.
- Gate sag and drag. The gate frame goes out of square when the diagonal tension cable loosens or the hinge post settles. The gate bottom scrapes the deck or pavers, and the latch misses the strike plate by half an inch or more.
- Panel bowing between posts. Vinyl panels in direct south or west exposure develop a permanent curve toward the sun. This is material fatigue, not wind damage, and it won’t pull straight with adjustment.
- Hardware seizure or corrosion. Gate hinges grind, latch bolts stick, or screws back out with white aluminum oxide crusting the threads. Salt air accelerates this; inland Miami sees it in 5-7 years, coastal Key Biscayne and Miami Beach in 3-4.
Before
AfterReplacement Cost & What’s Included
| Scope | Price Range |
|---|---|
| Single post replacement (vinyl) | $340-$620 |
| Single post replacement (aluminum) | $410-$780 |
| Rail section replacement (8 ft) | $280-$490 |
| Gate rebuild (hardware + frame adjust) | $590-$1,180 |
| Full panel replacement (vinyl, 6 ft × 8 ft) | $720-$1,340 |
| Complete fence installation, standard lot | $4,130-$10,620 |
The range depends on three factors: access for a mini-excavator or hand-dig, whether the original footing is reusable, and if we’re matching discontinued PGT colors. We quote a flat price with line-item breakdown before work starts. Under Clause 1 of the Haven Standard, that written number doesn’t change unless you sign a change order. Our 365-Day Done Right Promise covers the installation and hardware; PGT’s material warranty runs 20 years on vinyl and lifetime on aluminum structure, which we register for you.
DIY or Call Us?

There’s no high-tension danger in fence work, but there’s a precision problem. An owner can safely check if a post is loose by rocking it at the base, or confirm rail pull-out by lifting the rail end. What goes wrong in DIY is the footing: a post set in dry-pack concrete without proper drainage fails again in 18 months, and in Miami’s high water table, a 24-inch depth often isn’t enough.
We’ve rebuilt four DIY post replacements in the last two years in the Gables alone. The fix cost 40% more than our original quote because we had to extract the failed footing and start clean. Measure twice, write it down, then build it. If you’re pricing the job, call us at (786) 321-4970 for a written estimate you can compare against your material list.
FAQs
Vinyl posts and rails typically last 15-20 years in Miami’s climate; aluminum structure lasts 25-plus. The weak point is hardware: hinges, latches, and brackets need replacement at 5-8 years inland, 3-5 years on the coast. Call (786) 321-4970 and we’ll inspect what you’ve got and quote only what needs doing.
Rail pull-out and hardware failure are repairable. Post rot, panel bowing, or footing failure require replacement. We don’t quote replacement when repair will hold; our photo record shows you which is which before you decide. Call (786) 321-4970 for a free estimate.
A single post replacement takes 3-4 hours including cure time for concrete. A full residential installation runs 2-4 days depending on lot size and access. We don’t promise same-day completion on full installs; the footing needs proper cure time or the post leans by month three. Call (786) 321-4970 to schedule.
We stock PGT-compatible posts, rails, brackets, and Marine-grade hardware for common sizes: 5-inch vinyl posts, 2-inch aluminum posts, and standard 6-foot and 8-foot rail lengths. Custom colors and the Estate series ornamental cap styles we order for next-day delivery. Call (786) 321-4970 with your post label or measurements and we’ll confirm what’s in stock.
Written by Grant Rowan, Owner, Rowan Construction Group Miami at Rowan Construction Group Miami, serving Miami and nearby areas.







Before
After
Before
After