PGT Bathroom Remodeling Nationwide

PGT Bathroom Remodeling: The Miami Owner’s Guide

PGT bathroom remodeling in Miami typically runs $10,620-$33,040 for a full replacement, with small bath refreshes starting at $5,900. We stock PGT-compatible shower enclosures, glass panels, and hardware systems for same-day assessment, and most Miami homeowners discover an issue when the frameless glass starts leaking at the seal or the rolling door mechanism binds in the track. In Coral Gables last month, we measured a PGT Spa Door where the bottom guide had worn through its nylon bushing after six years of hard water exposure - the homeowner noticed water pooling outside the curb before any visible crack appeared.

Call (786) 321-4970

Which PGT Models This Applies To

PGT’s bathroom line breaks into three series that handle differently during replacement. The Spa Door series uses a 3/8-inch tempered glass with a proprietary bottom-track profile that PGT changed in 2019 - the post-2019 track is 1/4 inch wider, so mixed-era hardware binds. The ShowerGuard fixed panels rely on a U-channel wall mount with a specific 11/16-inch leg depth; standard 5/8-inch aftermarket channel leaves the panel proud of the tile by an eighth, and that gap collects mold in Miami’s humidity. The EuroVue rolling system runs on a dual-wheel truck with a 7/8-inch axle spacing that only two aftermarket suppliers replicate correctly.

We carry OEM PGT seals and rollers, plus verified equivalents from CRL and Prime-Line for discontinued series. The label is usually etched in the glass corner or printed on the hinge barrel - if it’s worn off, we measure track width, glass thickness, and axle spacing on-site rather than guess. Measure twice, write it down, then build it.

Signs Your PGT Bathroom Remodeling Is Failing

• Water pooling outside the shower curb. The vinyl or TPE bottom sweep has hardened in the Florida sun and no longer compresses against the threshold. We see this first in south-facing Miami bathrooms where glass surface temperatures hit 140°F in August.
• Door rolls rough or drops at one corner. The truck wheels have flat-spotted or the axle has corroded from salt-laden humidity, especially in beach-adjacent homes from Key Biscayne to Sunny Isles. The door feels heavier because it’s riding metal-on-metal.
• Glass panel shifts when pushed. The U-channel silicone has released from the tile substrate, often because the original installer used generic silicone instead of PGT-specified neutral-cure sealant that handles thermal cycling.
• Visible calcium streaks inside the glass edge. This means moisture has breached the tempered glass edge seal and is wicking into the laminations - in Miami’s hard water zones like Pinecrest and Palmetto Bay, this accelerates once it starts.
• Hinge squeaks or binds at 90 degrees. The brass hinge barrel has worn its nylon insert; PGT uses a 3-degree pre-set pivot angle that standard replacement hinges don’t replicate, so the door drifts open or closed on its own.

Before

After

Replacement Cost & What’s Included

The spread depends on three things we itemize in writing: whether the existing tile curb and walls are square enough for PGT’s tight tolerances (often they’re not in pre-1980s Miami concrete block), whether we need to source a discontinued series through PGT’s special-order channel, and whether the substrate behind the U-channel needs re-waterproofing with Schluter-Kerdi or equivalent. Every quote is a flat price with a written scope - no change proceeds without a signed change order, per Clause 1 of The Haven Standard. The 365-Day Done Right Promise covers installation and hardware; glass carries PGT’s 10-year limited warranty against seal failure.

DIY or Call Us?

There’s safe checking, and then there’s the part where a 3/8-inch tempered panel weighing 80 pounds slips off a worn truck and shatters across your tile. An owner can verify the model label, measure track width with a tape, and photograph the hinge or truck for us - that saves time on the phone. What goes wrong in DIY: ordering aftermarket wheels that don’t match the axle spacing, forcing them, and cracking the glass bore; or reusing the old sweep channel after the aluminum has corroded, which leaks within a month and rots the curb framing.

PGT glass is tempered, not laminated - it cannot be field-cut, and a mis-measure means a full reorder with a four-week lead time. We carry the trucks, seals, and sweeps on our service vehicles, and we measure with the door in place before quoting. Call (786) 321-4970 to schedule your free estimate.

FAQs